Convert to "sleek and smaller" turn signal setups & revisions for Beta RS?

[decooney]

Considering removing the factory Beta turn signals, storing them away in a box, and going with something smaller and sleeker. If I break them, just replace them...

SOURCES?
Anyone out there making a nice quality and bright front and rears 3/4 to 1/2 size of stock would be nice?

[justinandkarna]

I have been looking around for the same thing for my Bike and my Wife's Bike which we are about to Dual-Sport.

I think I am going with Sicass Racing's LED Flat Mount lights. Was able to check out a set on a friends bike, so far they are the most "dirt bike" turns signals I have seen.

[Haychip]

Here is a shot of what we do. Use the RR tail piece and flush mounts. These are just K&S cheapies. Mostly we use the Sikk Ass flush mounts. Also here are the Euro type, these signals have held up thru two desert races and a few hundred miles of just play riding. I really like them. They show up much better than the flush mount and although not DOT they look like they are.

[justinandkarna]

Ahhh, I had a new RR tail and sold it because I thought it was only a running light, not a brake light also.

Chip, price for a RR tail?

The picture with the CA license plate: What brand are those turn signals?

[chasejj]

Those are Sicass. I bought some from Chip to use on my new RR tailpiece. They appear to be a tight fit on the edge of the fender. Maybe even overlapping it a bit. I am thinking of maybe making a small plastic backing plate and riveting it to the fender with the TS attached so that the back rubber seal stays intact. if I do I will post a pic.

[justinandkarna]

Those are Sicass. I bought some from Chip to use on my new RR tailpiece. They appear to be a tight fit on the edge of the fender. Maybe even overlapping it a bit. I am thinking of maybe making a small plastic backing plate and riveting it to the fender with the TS attached so that the back rubber seal stays intact. if I do I will post a pic.

Great, thanks!

I removed my head from butt and found the price for the RR tailpiece, $53.99. Why did I ever sell mine? Duh

[Haychip]

The ones in the photo are just some cheapies, K&S brand. The Sikk Ass are better units. I only sell the ones with a stud so they bolt on as well as stick on. The K&S ones are only around 24 bucks, I think the Sikk Ass are quite a bit more. (sorry computers turned off for end of month accounting)

[jeff03064]

Here is a shot of what we do. Use the RR tail piece and flush mounts. These are just K&S cheapies. Mostly we use the Sikk Ass flush mounts. Also here are the Euro type, these signals have held up thru two desert races and a few hundred miles of just play riding. I really like them. They show up much better than the flush mount and although not DOT they look like they are.

Chip... the blinkers in the photo with no plate...not the flush mounts... are those LED? That's what I have on my 2010 450RR but I wasn't sure if they are LED or not. I want to change to flush mount but want to make sure I get whatever matches what I have on there now. (As far as being LED or not that is.)

[Haychip]

No they are not LED, Conventional.

[jeff03064]

Can I just swap conventional for LED? Will that work or do I need to change other stuff? (flasher relay?)